WAGO - 2002-1407 4-CONDUCTOR GROUND TERMINAL BLOCK, GREEN-YELLOW, SUITABLE FOR EX E II APPLICATIONS, PUSH IN CAGE CLAMP, 2.5MM2

Earth terminal block, 4 conductor, 2.5mm², Push-In Cage Clamp

This capable ATEX, rated yellow/green ground terminal block, suitable for Ex e II applications, has been designed for use in areas where the presence of vapours and gases in the atmosphere could prove dangerous if ignited by an errant spark. This terminal block fits 35mm DIN Rails and incorporates secure cage clamp technology, and is around 30% smaller than standard terminal blocks.

Versatile, this 4 conductor WAGO TOPJOB S single level DIN rail mount terminal block with operating slot, enables easy connection when using an appropriate tool which remains in the operating slot until termination is complete.  The clamping point is marked by the inserted tool and is held open, leaving hands free for wiring. This product can be ordered individually. For suitable endplates see part numbers 2002-1491 and 2002-1492.

The WAGO TOPJOB S range of DIN rail terminal blocks can also be fitted with marker tiles to assist engineers and electricians when wiring and fault finding. Approvals - AEx - UL 60079, ATEX - EN 60079, CCCEx - CNCA-C23-01, EAC - TP TC 012/2011, IECEx - IEC 60079

What are DIN Rail Mount Terminal Blocks used for?

DIN rail mount terminal blocks are designed to allow engineers and electricians to connect electrical circuit wiring to supply systems and other pieces of equipment such as motors, power supplies, fuses, etc.

Terminal blocks are one of the most widely used electrical connection products used within industrial electrical supply installations, establishing a semi-permanent link in an electrical supply system allowing power to pass around a circuit. Feed through terminal blocks also facilitate easy replacement and expansion should the demands of the system change.

?

Earth Terminal Block with Operating Slot Features

• 4 Copper conductors, single level
• Suitable for Ex e II applications
• Green and Yellow – earth/ground terminal
• Push-in cage clamp technology
• Front entry wiring
• Centre and side marking
• Wire size 22- 12 AWG, Nominal cross section 2.5 mm²
• DIN Rail mounting 35 x 15 mm & 35 x 7.5 mm
• Dimensions HxWxD 69.9 x 5.2 x 32.9 mm
• Polyamide (PA66) construction
• Operating temperature -60 to +105 °C
• EX Approvals - AEx, ATEX, CCCEx, EAC, IECEx