WAGO - 2004-1301 GREY THROUGH TERMINAL BLOCK, 3 CONDUCTOR, 4 MM², PUSH-IN CAGE CLAMP, OPERATING SLOT, SUITABLE FOR EX E II APPLICATIONS

Grey through terminal block, 3 conductor, 4 mm², for EX e II Applications

This capable ATEX, rated blue terminal block, suitable for Ex e II applications, has been designed for use in areas where the presence of vapours and gases in the atmosphere could prove dangerous if ignited by an errant spark. This terminal block fits 35mm DIN Rails and incorporates secure cage clamp technology, and is around 30% smaller than standard terminal blocks.

Versatile, this 3 conductor WAGO TOPJOB S single level DIN rail mount terminal block with operating slot, enables easy connection when using an appropriate tool which remains in the operating slot until termination is complete.  The clamping point is marked by the inserted tool and is held open, leaving hands free for wiring. This product is also available to order individually. For suitable endplates see part numbers 2004-1391 and 2004-1392.

The WAGO TOPJOB S range of DIN rail terminal blocks can also be fitted with marker to assist engineers and electricians when wiring and fault finding. Approvals - AEx - EN 60079, ATEX - EN 60079, CCCEx - CNCA-C23-01, EAC - TP TC 012/2011, IECEx - IEC 60079, INMETRO – IEC 60079

?

Grey Terminal Block with Operating Slot Features

• 3 copper conductors, single level
• Suitable for Ex e II applications
• Direct plug-in of rigid and flexible conductors with end tips
• Centre and side marking
• Push-in cage clamp technology
• Front entry wiring
• Voltage rating 800 V, Current rating 32 A
• Rated impulse current 8 kV
• Wire size 20- 10 AWG, Nominal cross section 4 mm²
• DIN Rail mounting 35 x 15 mm & 35 x 7.5 mm
• Dimensions HxWxD – 65.5 x 6.2 x 32.9 mm
• Grey Polyamide (PA66) construction
• Operating temperature -60 to +105 °C
• EX Approvals - AEx, ATEX, CCCEx, EAC, IECEx, INMETRO

What are DIN Rail Mount Terminal Blocks used for?

DIN rail mount terminal blocks are designed to allow engineers and electricians to connect electrical circuit wiring to supply systems and other pieces of equipment such as motors, power supplies, fuses, etc.

Terminal blocks are one of the most widely used electrical connection products used within industrial electrical supply installations, establishing a semi-permanent link in an electrical supply system allowing power to pass around a circuit. Feed through terminal blocks also facilitate easy replacement and expansion should the demands of the system change.