WAGO - 2116-1204 BLUE TERMINAL BLOCK WITH LEVER, OPERATING SLOT, TEST PORT, PUSH-IN CAGE CLAMP, SINGLE LEVEL, 2 CONDUCTORS, 16 MM2, EX APPROVED

Blue Terminal Block with Lever, Operating Slot, Test port,  2 conductors, 16 mm²

This blue WAGO TOPJOB S DIN rail mount terminal block with built in lever, test port and operating slot makes it easy to connect terminal conductors without tools. This terminal has been designed for Ex i applications and features a 2-conductor single level, with a nominal 16 mm2 capacity and cage clamp technology.

Using the built-in lever, opening and closing a clamping point by hand couldn’t be any easier. Ideal for making connections in the field with the ease of handling offered by this intuitive design. The connection is secured when the easy-to-use lever is quickly and simply lowered into closed position

The levers remain open for the simultaneous connection of difficult-to-bend conductors with large cross sections. Thanks to Push-in cage clamps, solid and stranded conductors, as well as fine-stranded conductors with gas-tight crimped ferrules, can be connected by push-in termination. For suitable end plate see 2116-1292.

This capable ATEX rated terminal block has been designed for use in areas where the presence of vapours and gases in the atmosphere could prove dangerous if ignited by an errant spark. Ex- Approvals - AEX - UL 60079, ATEX - EN 60079-0, CCCEx - CNCA-C23-01, EAC – TP TC 012/2011, IECEx IEC 60079-0, INMETRO - IEC 60079.

?

Blue Terminal Block with Lever Features

• Suitable for Ex applications
• 2 Copper conductors, single level
• Lever operation with operating slot, test port
• Push-in cage clamp technology
• Front entry wiring
• Voltage rating 800 V, Current rating 76 A
• Rated impulse current 8 kV
• Wire size 20- 6 AWG, Nominal cross section 16 mm²
• DIN Rail mounting 35 x 15 mm & 35 x 7.5 mm
• Dimensions HxWxD 91.5 x 12 x 36.9 mm
• Blue Polyamide (PA66) construction
• Operating temperature -60 to +105 °C
• Ex Approvals - AEx, ATEX, CCCEx, EAC, IECEx, INMETRO

WAGO TOPJOB S Terminal Block with Lever Benefits

• Manual lever actuation, operating slot, test port
• Raised lever stays open, freeing hands for quick and easy wiring
• The levers position signals whether the clamping point is open or closed
• Push-in cage clamp allows connection of both solid and fine-stranded conductors with ferrules
• Can also be fitted with marker tiles for improved identification

What are DIN Rail Mount Terminal Blocks used for?

DIN rail mount terminal blocks are designed to allow engineers and electricians to connect electrical circuit wiring to supply systems and other pieces of equipment such as motors, power supplies, fuses, etc.

Terminal blocks are one of the most widely used electrical connection products used within industrial electrical supply installations, establishing a semi-permanent link in an electrical supply system allowing power to pass around a circuit. Feed through terminal blocks also facilitate easy replacement and expansion should the demands of the system change.